Setting Test Parameters - GE Healthcare Optima XR200amx Installation Manual

GE H
EALTHCARE
D 5336113-1EN, R
IRECTION

3.5.1.3 Setting test parameters

1.
2.
Table 3-2 Ground resistance test parameters
3.
4.
5.
6.
Page 40
10
EVISION
Turn on the tester by pressing the POWER button.
The tester enters the ready state five seconds after startup (the model name and version
display during startup).
Verify that the tester displays the test parameters specified in
Test parameters
Current
Test value
Timer
If it does not, perform the following steps to change the parameters as needed (the system will
save the settings even after system power is turned off). See
A. While in the ready state, press the
begins flashing.
B. Press the
0.1-A increments. To change the value by 1.0-A increments, press
button.
C. Press the button again to move to each of the other settings (Maximum Test
Value, Timer, and Frequency).
D. Use the
E. Press .
Figure 3-8 Test parameter value settings
While in the ready state, press the
setting screen.
The Output Current Frequency is the first digit displayed, where the value is 0 for 50 Hz or 1
for 60 Hz. The Pass/Fail hold function is represented by the second digit.
Press the or button until the second digit begins flashing.
Press the button to change the value to 1
Press the + buttons to save this setting and return to the ready state. The unit will
display and hold the measured resistance value after the test.
Section 3.5 Ground and leakage testing
Values
Canada: 30.0 A
All other countries: 25.0 A
0.100 Ohms
5.0 sec
or
or button to change the output current. The value changes in
or + buttons as needed to adjust the values.
+
(Figure
O XR200
PTIMA
I
NSTALLATION
Table 3-2.
Figure 3-8.
button until the output current display
buttons to display the Optional function
3-9).
/XR220
AMX AMX
M
ANUAL
+ or