Table of Contents
Advertisement
Installation (continued)
r Install the projector to a ceiling
Shaft
Groove
Ball joint
fixing screw
Shaft
22 - ENGLISH
Attachment plate
Projector mount bracket
Groove
1) Changing the orientation of the main unit of
the projector.
z Refer to "Changing the orientation of the
main unit of the projector" ( page 17),
adjust the orientation of the main unit of the
projector as shown in the left illustration and
then fasten the ball joint fixing screw.
2) Attach the groove of the projector mount
bracket to the shaft of the attachment plate.
Warning:
The mounting and installation must be carried
out by two or more persons.
3) Attach the projector mount bracket to the
attachment plate.
z Slide the projector mount bracket and make
the groove of the projector held on to the
shaft of the attachment plate.
Attention
z Do not release your hand until the
attachment plate is fitted into both sides (the
shaft side and the hook side) of the projector
mount bracket.
Hook
4) Secure the projector mount bracket to
the attachment plate with the screws and
captive washers.
z Firmly secure the projector mount bracket
with the four supplied screws and captive
washers (M4 x 8).
Advertisement
Table of Contents
