Fujitsu AIRSTAGE UTP-RX04BH Installation Manual page 9

7.3.4. Work procedure
(1) Remove the control box cover. (3 screws)
(2) Connect the transmission cable to the transmission cable terminal.
(3) Firmly attach the transmission cables using the accessory cable ties. (Up to 5 loca-
tions)
(4) Connect the power supply cable to the power supply cable terminal.
(5) Firmly fi x the power supply cable clamp in place.
(2) Transmission cable
To outdoor unit / other RB unit /
indoor unit (Cooling only)
(6)
(2) Transmission cable
to indoor unit
(3)
[INDOOR UNIT D]
C
(6)
(2) Transmission cable
to indoor unit
(3)
[INDOOR UNIT C]
(6)
(2) Transmission cable
to indoor unit
(3)
[INDOOR UNIT B]
(6)
(2) Transmission cable
to indoor unit
(3)
[INDOOR UNIT A]
(6)
(3)
(4) Power supply cable
(6)
(5)
A
B
PC board
PC board
PC board
PC board
Detail A : Power supply cable
Earth (ground)
Detail B : Transmission cable
Earth (ground)
To outdoor unit / other
RB unit / indoor unit
(Cooling only)
Detail C : Transmission cable
To indoor unit
(cooling / heating)
(Do not use)
(6) Fill the cable holes with putty in order to prevent small animals from entering.
(7) Install the Control box cover. (3 screws)
En-8