Advertisement
2.
Remove any existing cable ties and unplug the ABS TTMA 5 pin connector to disconnect
the main harness from the ABS harness.
ABS
Harness
Cable
Tie
Main
Harness
3.
Install the EZTrac™ GPS Device inline between the disconnected male and female connectors.
Page 2
PHILLIPS CONNECT TECHNOLOGIES
1 2 0 1 2 B U R K E S T R E E T, S A N T A F E S P R I N G S , C A 9 0 6 7 0
ABS
Harness
ABS
Harness
Unplug
Disconnect
ABS Harness
Here
and Main
Harness
Main
Main
Harness
Harness
ABS
Harness
EZTrac™
Device
PCT-EZTIG REV3_8-21-19
T E L : 8 8 8 . 8 8 0 . 6 8 9 0
W W W . P H I L L I P S - C O N N E C T. C O M
4.
Make sure to align and secure the locking clip between the ABS Harness and EZTrac™ GPS
Device connection. Place one (1) cable tie over the locking clip to prevent the connection
from pulling apart.
Align and Secure
Lock Clip
5.
Insert 14" x 2" split loom over the EZTrac™ GPS Device.
14" x 2" Split loom
Insert 14" x 2" Split loom Over EZTrac™ Device
6.
Secure the entire EZTrac™ GPS Device to the main harness with two (2) additional
cables ties as shown below.
7.
Power up the asset.
PCT-EZTIG REV3_8-21-19
PHILLIPS CONNECT TECHNOLOGIES
1 2 0 1 2 B U R K E S T R E E T, S A N T A F E S P R I N G S , C A 9 0 6 7 0
PHILLIPS CONNECT TECHNOLOGIES
T R A N S P O R T A T I O N T E C H N O L O G I E S R E I M A G I N E D
Place Cable Tie
Over Clip to Secure
EZTrac™ to Harness
T E L : 8 8 8 . 8 8 0 . 6 8 9 0
W W W . P H I L L I P S - C O N N E C T. C O M
Page 3
Advertisement
