Welding Power Source And Output Side - Panasonic YD-200KR Operating Instructions Manual

CONNECTION (CONTINUED)
 Welding Power Source and Output Side
①Turn off the power switch.
③Open upward the terminal cover
located at the lower part of the
operation.(after completing
connections, connect the wire
feed control cable to the plug
socket shown on the next page and
put back the terminal cover)
②Remove two bolts from
the terminal cover.
⑦Connect the other end
of the base metal cable
to the base metal.
⑧Ground the base metal
Plus
terminal
Minus
terminal
Base Metal
Cable
５
PREPARATIONS
Terminal cover
④Using an accessory
bolt,
base metal cable to
the
terminal.
⑤ Using an accessory
bolt, connect the output
cable coming from the
wire feeder
plus(+) terminal.
⑥ Tape around any
conductive sections which may
come into contact with other
parts.
connect the
minus(-)
to the
Installing
tape
exposed