Power Board; Bluetooth Module - Sony SA-WX9000F Service Manual

SA-WX9000F/WXF9000
2-5.

POWER BOARD

2 Remove two cables
from the clamp (N).
3 POWER board cable
connector (CN8102)
hole
5
hole
4 two screws
(BVTP3 8)
4 two screws
(BVTP3 8)
6 POWER board
2-6.

BLUETOOTH MODULE

Note 1: When the bluetooth module is replaced, be sure to refer to
"WIRELESS CONNECTION (LINK) WORK OF BAR
SPEAKER AND SUBWOOFER" on page 4.
AMP block
2 screw
(BVTP3 8)
1 Draw the FFC (26P)
out of the connector.
front side
10
top side
AMP block
rib
rear side
rib
bottom side
1 power-supply cord
connector (CN901)
Note 1: When installing the POWER board,
align the two ribs and two holes.
6 bluetooth module
top side
Note 2: The two cables must not touch the heat sink.
SK1-SUB-JACK board cable
top side
SK1 SUB MAIN board
Note 2: When installing the
bluetooth module,
align the boss and hole.
terminal side
hole
rear side
POWER board cable
heat sink
POWER board
clamp (N)
3 Lift up the bluetooth module
in the direction of the arrow.
5 hook
4 boss