Table of Contents
Advertisement
Attaching the Lens / Detaching the Lens (continued)
Lens calibration
Perform lens calibration after attaching the lens.
The lens calibration procedure differs depending on the projector you are using and the
main version of the firmware.
z PT-SRQ32KC / PT-SRZ31KC / PT-SRS30KC: Main version is 3.00 or later
Refer to "Case 1" ( x page 8).
z PT-SRZ21KC / PT-SRS20KC: Main version is 2.00 or later
Refer to "Case 1" ( x page 8).
z PT-SRQ13KC / PT-SRZ12KC / PT-SRS11KC / PT-SDZ21K2C / PT-SDS20K2C /
PT-SDW17K2C / PT-SDZ18K2C / PT-SDZ985C / PT-SDS955C / PT-SDW935C / PT-SDZ981C
Refer to "Case 2" ( x page 10). (Only ET-D3LEW50C is supported)
■ Case 1
z PT-SRQ32KC / PT-SRZ31KC / PT-SRS30KC (main version of the firmware is 3.00 or later)
z PT-SRZ21KC / PT-SRS20KC (main version of the firmware is 2.00 or later)
PROJECTOR SETUP
PROJECTOR ID
PROJECTION METHOD
LENS
OPERATION SETTING
LIGHT OUTPUT
BRIGHTNESS CONTROL
STANDBY MODE
NO SIGNAL SHUT-OFF
NO SIGNAL LIGHTS-OUT
INITIAL STARTUP
STARTUP INPUT SELECT
DATE AND TIME
MENU SELECT
SUB MENU
执行
LENS
LENS TYPE
LENS INFORMATION SETTING
LENS MEMORY
LENS HOME POSITION
ACTIVE FOCUS OPTIMIZER
LENS CALIBRATION
MENU SELECT
SUB MENU
执行
8-ENGLISH
1/2
ALL
NORMAL
100.0%
AUTO
NORMAL
DISABLE
DISABLE
LAST MEMORY
LAST USED
ET-D3LEW60C
1)
Press the < 菜单 > button.
2)
Use the ▲ and ▼ buttons to
select [PROJECTOR SETUP],
and press the < 执行 > button.
z The [PROJECTOR SETUP] screen
appears.
3)
Use the ▲ and ▼ buttons to
select [LENS], and press the
< 执行 > button.
z The [LENS] screen appears.
4)
Use the ▲ and ▼ buttons to
select [LENS CALIBRATION],
and press the < 执行 > button.
z The [LENS CALIBRATION] screen
appears.
z When the ET-D3LEW50C is
attached, a confirmation screen
appears when the < 执行 > button is
pressed. In such cases, proceed to
step 6.
Advertisement
Table of Contents
