Table of Contents
Advertisement
Preparation (continued)
Lens calibration
Perform lens calibration after attaching the lens.
The lens calibration procedure differs depending on the projector you are using and the
main version of the firmware.
z PT-RQ32K / PT-RZ31K / PT-RS30K / PT-RQ22K / PT-RZ21K / PT-RS20K
Refer to "Case 1" ( x page 7).
z PT-RQ13K / PT-RZ12K / PT-RS11K / PT-DZ21K2 / PT-DS20K2 / PT-DW17K2 /
PT-DZ16K2 / PT-DZ13K / PT-DS12K / PT-DW11K / PT-DZ10K
Refer to "Case 2" ( x page 9).
■ Case 1
z PT-RQ32K (main version of the firmware is 3.16 or later)
z PT-RZ31K / PT-RS30K (main version of the firmware is 3.09 or later)
z PT-RQ22K (main version of the firmware is 1.05 or later)
z PT-RZ21K / PT-RS20K (main version of the firmware is 2.07 or later)
PROJECTOR SETUP
PROJECTOR ID
PROJECTION METHOD
LENS
OPERATION SETTING
LIGHT OUTPUT
BRIGHTNESS CONTROL
STANDBY MODE
NO SIGNAL SHUT-OFF
NO SIGNAL LIGHTS-OUT
INITIAL STARTUP
STARTUP INPUT SELECT
DATE AND TIME
MENU SELECT
SUB MENU
ENTER
LENS
LENS TYPE
LENS INFORMATION SETTING
LENS MEMORY
LENS HOME POSITION
ACTIVE FOCUS OPTIMIZER
LENS CALIBRATION
MENU SELECT
SUB MENU
ENTER
1/2
ALL
NORMAL
100.0%
AUTO
NORMAL
DISABLE
DISABLE
LAST MEMORY
LAST USED
ET-D3LEW200
The illustrations in this procedure depict
use of the ET-D3LEW200 as an example.
1)
Press the <MENU> button.
2)
Use the ▲ and ▼ buttons to
select [PROJECTOR SETUP],
and press the <ENTER>
button.
z The [PROJECTOR SETUP] screen
appears.
3)
Use the ▲ and ▼ buttons to
select [LENS], and press the
<ENTER> button.
z The [LENS] screen appears.
4)
Use the ▲ and ▼ buttons to
select [LENS CALIBRATION],
and press the <ENTER>
button.
z The [LENS CALIBRATION] screen
appears.
z When the ET-D3LEU100 is attached,
a confirmation screen appears when
the <ENTER> button is pressed. In
such cases, proceed to step 6.
ENGLISH-7
Advertisement
Table of Contents
