Epson Stylus Pro 10000 Archival Ink Quick Reference Manual
C362111arc
Hide thumbs
Also See for Stylus Pro 10000 Archival Ink:
- Service manual (376 pages) ,
- User manual (174 pages) ,
- Printer manual (168 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Epson Stylus Pro 10000 Archival Ink
Summary of Contents for Epson Stylus Pro 10000 Archival Ink
-
Page 1: Epson Stylus Pro
EPSON Stylus Pro 10000 ® Quick Reference Guide... -
Page 2: Loading Roll Paper
Loading Roll Paper Loading Roll Paper First you attach the paper roll to the spindle and place the spindle in the printer. Then you load the paper for printing. Setting Up the Paper and Spindle Open the roll paper cover and lift out the spindle. Slide the movable paper stop off the left end of the spindle. -
Page 3: Loading Roll Paper For Printing
Loading Roll Paper (Continued) Loading Roll Paper (Continued) Loading Roll Paper for Printing Once the roll paper is attached to the spindle and inserted in the printer, you’re ready to load it for printing. Make sure the printer is turned on. Then press the button repeatedly until one of the Paper Source lights comes on (either... -
Page 4: Printing On Posterboard
Loading and Using Cut Sheet Paper Loading and Using Cut Sheet Paper Make sure roll paper is not loaded for printing, and the roll paper cover is closed. Press the button repeatedly until the Paper Source light comes on. Sheet Make sure the paper set lever is all the way in, in the secured position. -
Page 5: Checking And Cleaning The Print Head
Checking and Cleaning the Print Head Checking and Cleaning the Print Head First you print a nozzle check pattern to see if the print head needs cleaning. If dots are missing from the pattern, you need to run a cleaning cycle. After cleaning, run another nozzle check. -
Page 6: Aligning The Print Head
This process aligns the head for all modes and resolutions. You can use EPSON roll paper to print the alignment patterns. Two rows consisting of sets of 15 bars are printed across the width of the paper. It takes about 10 minutes to print both rows. -
Page 7: Printer Status
Checking Ink Levels and Replacing Ink Cartridges Checking Ink Levels and Replacing Ink Cartridges Before you begin a large print job, you should check your ink levels. If one of your cartridges is low, you can replace it before you start. Or, you can wait until the ink runs out, replace the cartridge, and then continue the job without any loss of print quality. - Page 8 Replacing Ink Cartridges (Continued) Replacing Ink Cartridges (Continued) Carefully pull the empty cartridge straight out of the printer. If ink gets on your hands, wash them thoroughly with soap and water. If ink gets into your eyes, flush them immediately with water. Make sure the replacement cartridge is the correct color, and remove it from its package.
-
Page 9: Status Messages
Make sure the right paper is loaded print options is different and the paper source setting is the from control panel. same on the control panel and print options. A maintenance part will Note the error number and contact need to be replaced soon. EPSON. Continue... -
Page 10: Where To Get Help
World Wide Web EPSON E-MAIL technical support Support for non-EPSON RIP EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON Preferred is a service mark of Epson America, Inc. Copyright © 2001 by Epson America, Inc. Explanation Paper has jammed in the printer. - Page 11 EPSON Stylus Pro 10000 ® Printed in USA CPD-12209...