Epson PowerLite 737c User Manual page 65

9. Select
Internet Protocol
see this screen:
10. If your access point uses DHCP, select
. Otherwise select
automatically
and enter the required information:
: Type in the IP address you want to assign to the
IP address
computer. It must be formatted like other addresses on the
network. The last section must be unique.
Subnet mask
depends on how your network is set up.
Default gateway
the access point when it was set up.
11. When you're done, click
12. Click the
Wireless Networks
(If you don't see this tab, you may need to enable your wireless
card or adapter by clicking
settings; then follow any instructions on the screen to enable the
device.)
and click the
Properties
Obtain an IP address
Use the following IP address
: For example: 255.255.255.000, but this
: Enter the IP address that was assigned to
.
OK
tab.
to access the device
Configure
button. You
note
For specific details about
your network, please consult
your network administrator.
note
If you don't know your
gateway or access point
address, see page 67.
Presenting Through a Wireless Network
65