Setting The Temperature; Inserting/Removing Bottles - Silvercrest SWTS 65 A1 Operating Instructions Manual

Setting the temperature

You can set a temperature between 7 and 18°C (45–64°F).
NOTE
► The appliance is equipped with an automatic key lock. If no button is
pressed for approx. 20 seconds, the
To deactivate the key lock, hold down the button
onds until you hear a second beep.
► The appliance cannot be used for heating. If the ambient temperature is
cooler than the set temperature, the cooling switches off. The temperature
in the interior then reaches the ambient temperature at most.
Press
temperature by 1°C or °F respectively. The display
programmed temperature. If you do not press another button, the flashing stops
and the display
The appliance now cools down slowly to the set temperature.

Inserting/removing bottles

The appliance is designed for a maximum of eight standard beverage bottles
with a maximum length of approx. 33 cm.
NOTE
► It is usually somewhat cooler in the lower part than in the upper part of
the appliance. Therefore, always fill the appliance from bottom to top and
place the bottles or foods which require most cooling in the lower area.
► Taller bottles and containers with a maximum overall height of approx.
34 cm can also be placed upright in the appliance. To do this, remove
the shelves
You can pull out the shelves
To do this, pull the shelves
appliances stop the shelves
Push the shelves
■ 12 │ GB │ IE │ NI
button or button
shows the current temperature inside the appliance again.
.
to make it easier to insert and remove the bottles:
out of the appliance until the two locking
back into the appliance as far as the stops.
and
to increase or decrease the desired
flashes and shows the
in the rail.
buttons are locked.
for approx. 3 sec-
SWTS 65 A1