1: 5880 Board Layout; 2: Facp Connection; 3: Led Wiring - Honeywell 6820 Manual

5880 LED I/O Module
4.13.1 5880 Board Layout
Figure 4.34 shows the locations of screw terminals for connection to the panel and contact monitor wiring, pin connectors for connecting
LEDs and the DIP switch for selecting an SBUS ID number for the 5880.
4.13.2 FACP Connection
The 5880 connects to the panel via the SBUS. Make connections as shown in Figure 4.35. After the 5880 is connected to the panel, it must
be added to the system. This programming step is described in Section 8.2.2.
4.13.3 LED Wiring
There are four 12-pin connectors on the 5880 board for connecting LEDs. Each LED gets its power from Pin 11. Internal resistors are sized
so that there is approximately 10 mA of current for each LED; no series resistors are required. LED outputs can be mapped to output circuits.
See Section 8.5.4 for programming details.
Wire the LEDs as shown in Figure 4.36.
6820/EVS Manual — P/N LS10144-001SK-E:E 4/6/2022
dry contact inputs- supervised, power-limited
IN - 48 C+ IN - 47 IN - 46 C+
P1
P2
10 11
1 20
LED Out LED Out
LED Power
LED Power
not used
not used
Figure 4.34 5880 Board Layout
FACP
EXT. COMM
Figure 4.35 5880 Connection to 6820
IN - 45 IN - 44 C+ IN - 43 IN - 42 C+ IN - 41
P3 P4
30 31
21
LED Out
LED Out
LED Power
LED Power
not used
not used
S- S+ B
A
SBUS Connector
5880
S- S+
Control Panel Installation
40
SBUS (ID#) Address
DIP switch
A B
supervised,
power-limited
45