LG Split DOAS Set Up Reference Guide
On Boarding Process
‐. Main Module (via LGMV)
1. Activate the program(RFPGUI) on your PC(Laptop)
2. Go to 'Config' 'Select Device'
3. Select 'RX210_Series' Click Device 'R5F5210AB' Click 'OK'
4. Go to 'Config' 'Select UART'
5. Select compatible UART Port Click 'config'
6. Select 38400 at 'Byte/sec' Category Click 'OK'
* Recommend communication speed is below 38400
7. Click 'Code Flash' Select Firmware
8. Click 'Start' Check 'OK' is appeared after upgrade
‐. Hardware Setting
1. Dip SW #1 On
2. Connect LGMV and CN_UART
3. After Finishing Onboarding, disconnect LGMV and set back DIP SW #1 Off
(e.g [DOAS] Main_SAA39108423_1D9D_0xD0F870DE_MP1_20211113)