Table of Contents
Advertisement
Step Two - Making Basic Connections
Next you will need to connect your television to an antenna or cable system. The most basic
antenna/cable connection is shown below. For more detailed connections, such as ones where
a cable box is required, see pages 15 to 16.
1) Connect an RF cable out from the wall outlet in to the RF Input on the back of the TV.
You may also wish to connect a VCR at this point. A basic VCR connection is shown below.
For detailed instructions on connecting a other components or a home theater system, see
pages 15 to 17.
Note: A VCR is not required to operate your television.
1) Connect the yellow video cable out from the VCR's Video Output, in to the TV's Video Input
jack, OR connect an S-Video cable from the VCR's S-Video output, to the TV's S-Video
input.
2) Connect the white audio cable out from the VCR's Left Audio Output, in to the TV's Left
Audio Input Jack.
3) Connect the red audio cable out from the VCR's Right Audio Output, in to the TV's Right
Finally, once you have finished your connections, plug the power cord into the nearest power
outlet and turn on the television.
12
Downloaded from:
https://www.usersmanualguide.com/
Quick Setup 2
INPUT 1
S-VIDEO
OVER
VIDEO
AUDIO OUT
AUDIO
L/MONO
L/MONO
L
R
R
R
INPUT 1
INPUT 2
COMPONENT
S-VIDEO
VIDEO
OVER
VIDEO/Y
VIDEO
AUDIO OUT
AUDIO
L/MONO
L/MONO
P
B
L
P
R
R
R
R
Audio Input jack.
Proceed to Step Three
WALL
CABLE or ANTENNA
OUT
Cable/RF connector
INPUT 2
COMPONENT
VIDEO
75Ω
VIDEO/Y
(VHF/UHF)
P
B
P
R
V L R
IN
OUT
OR
75Ω
(VHF/UHF)
Illustration of AV-27D303
VCR
AV Cables/Plugs
Illustration of AV-27D303
Advertisement
Table of Contents
