Programming And Diagnosis Software; Installing The Programming And Diagnosis Software - Bosch ABS M4 Kit Manual

9 | Programming and Diagnosis Software

26 / 60
9 Programming and Diagnosis Software
The following chapter introduces the programming and diagnosis software.
9.1 Installing the Programming and Diagnosis
Software
After installing the MSA Box II you need to install the programming and diagnos‐
tic software RaceABS 1.1.x. You can find the software including the installation for
free download on our website: www.bosch‐motorsport.de.
Switch on the ignition
Plug the MSA Box's USB connector into your laptop and its motorsport connec‐
tor into the ABS M4 wire harness diagnostic interface to enable communication.
A green status indicator shows when the connection is successful.
The installation will place an icon on your desktop to the RaceABS software. After
the installation is complete, you can launch the application by clicking on the
RaceABS icon. If you try to launch the software without the MSA Box II being
connected to the laptop, the status indicator in Explorer flashes red and yellow
and an error message appears in the status bar:
Sometimes especially in the familiarization phase the following
messages pop up:
This problem message occurs when the connection to the diagnostic interface is
interrupted:
This problem message occurs when either the ABS‐ECU gets no power supply
(e.g. ignition off) or the MSA Box II is not connected to the wiring harness. Please
make sure that the connection between the diagnosis software and MSA Box II is
assured:
Colors of he status indicator
In online mode the status indicator can shine in the following colors:
red no connection
ABS M4 Manual Bosch Motorsport