6 Installer Setup Operation Setup; Heat - Panasonic WH-ADC0509L3E5 Operating Instructions Manual

Menu

6 Installer setup Operation setup

To access to the four major
functions or modes.
6.1

Heat

To set various water & ambient
temperatures for heating.
* The system is locked to operate without COOL mode. It can be unlocked only by authorised installers or our authorised service partners.
1
* Only displayed when COOL mode is unlocked (This means when COOL mode is available).
2
Default Setting Setting Options / Display
4 main modes
Heat / * * Cool / * *
1, 2 1,
Water temp. for heating ON /
Outdoor temp. for heating OFF /
T for heating ON /
Heater ON/OFF
Water temp. for heating ON
Heating ON
temperatures in
Compensation curve
compensation curve
or direct input.
Water temp. for heating ON Compensation curve
Input the 4
temperature points
X axis: -5 °C, 15 °C
(2 on horizontal X
Y axis: 55 °C, 35 °C
axis, 2 on vertical Y
axis).
• Temperature range: X axis: -20 °C ~ 15 °C, Y axis: See below
• Temperature range for the Y axis input:
WH-WDG model: 20 °C ~ 75 °C
Regardless of the above setting, there is a limit to the water temperature. Refer to
the operating condition on page 3.
• If 2 zone system is selected, the 4 temperature points must also be input for Zone
2.
• "Zone 1" and "Zone 2" will not appear on the display if only 1 zone system.
Water temp. for heating ON Direct
Temperature for
35 °C
heating ON
• Min. ~ Max. range is 20 °C ~ 75 °C:
WH-WDG model: 20 °C ~ 75 °C
Regardless of the above setting, there is a limit to the water temperature. Refer to
the operating condition on page 3.
• If 2 zone system is selected, temperature set point must input for Zone 2.
• "Zone 1" and "Zone 2" will not appear on the display if only 1 zone system.
Auto / Tank
2
Heat ON: Water temp.:Zone1
55 ° C
35 ° C
Select
Operation setup
Heat ON: Water temp.:Zone2
Range: (20 ° C~75 ° C)
Steps: ±1 ° C
Select
75
20
-5 ° C 15 ° C
-20 15
Confirm
10:34am,Mon
° C
35
Confirm
43