Table of Contents
Advertisement
Alarm output Tab — Setting the
Alarm output
You can perform setting in this menu to control the
alarm output of the I/O port on the rear of the camera
linked to alarm detection function.
Tip
For details on connection of peripheral devices to the
alarm output of the I/O port, refer to the supplied
Installation Manual.
Duration
Duration 1, 2
Enter the duration for which the alarm is output,
between 1 sec. and 60 sec.
Memory card trouble detection
Set to output the alarm when trouble of the memory card
is detected.
Output port 1, 2
Check the I/O port number that outputs the alarm when
the trouble of memory card is detected.
OK/Cancel
See "Buttons common to every menu" on page 23.
Edge Storage Tab — Setting the
Edge Storage movie and still image
function
With Edge Storage, video or audio signal can be
recorded from the alarm detection results, such as
network block, recorded video and audio can be
streamed with the same protocol as the real-time
streaming.
Notes
• The frame rate and operability on the main viewer
may be reduced during movie or still image recording.
• The actual interval of recording a still image may be
longer than the interval you set.
• Stop the Edge Storage recording before you turn off
the power of the camera with a memory card inserted.
• Before you remove or insert a memory card, stop the
Edge Storage recording and turn off the power of the
camera.
• Before using a memory card, format it by Format
memory card in the Initialize tab of the System menu
(page 26).
• A maximum of 4000 movie records can be saved to a
memory card. If the checkbox of Overwrite is not
selected when the number of records reaches 4000,
new recordings cannot be made. If the checkbox of
Setting the Action output — Action output Menu
67
Advertisement
Table of Contents
