Settings; Schedule; Cutting Height; Operation - Husqvarna AUTOMOWER 320 NERA Operator's Manual

This chapter gives information about the settings for
the product that you can make in the Automower
Connect app. All setting for the product are available in
®
Automower Connect. Some settings can also be made
®
in Automower Access, refer to
page 9 . The product has factory settings but the settings
can be adapted for each work area.

4.1 Schedule

Schedule you can change the schedule settings for
In
the product.
Schedule function controls which hours the product
The
operates. When the product does not operate, it is
parked in the charging station. You can see which hours
and days the product operates in the schedule overview
in the app.
You can set the Schedule if the work area is less
than the maximum area capacity of the product. This
prevents wear on the grass and the product. The factory
schedule setting lets the product operate around the
clock 7 days a week.
To calculate the schedule setting, refer to
the schedule setting on page 20 .
4.1.1 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2 2
2. Divide the m / ft
operation capacity. Refer to table below.
3. The result is equal to the number of hours that the
product must operate each day.
Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
has a lot of slopes or obstacles, you need to increase
Schedule settings.
the
Model
®
Automower 320
®
Automower 430X
®
Automower 450X
Example: A lawn of 1000 m
®
Automower 320.
2
1000 m / 92 ≈ 11 h.
2
10700 ft / 990 ≈ 11 h.

20 - Settings

®
Automower Access on
To calculate
of the lawn with the approximate
Approximate operation capaci-
2 2
ty, m /h / ft /h
92 / 990
133 / 1430
208 / 2240
2 2
/ 10700 ft , cut with an
4 Settings
Days / week
®
7

4.2 Cutting height

4.2.1 Adjust the cutting height
The cutting height can be adjusted from 2 cm / 0.8 in. to
6 cm / 2.4 in.
4.2.2 TargetHeight
Use the TargetHeight function to lower the cutting height
from the maximum cutting height to the specified cutting
height gradually during 10 days. If you change the
cutting height manually during this time it will disable the
TargetHeight function.

4.3 Operation

2 2
/ ft .
Operation you can change the operation settings of
In
the product.
4.3.1 Spiral cutting
If the product enters an area where it senses the grass
is longer than average, it can change the movement
pattern to
mows in a spiral pattern to faster cut the area with
longer grass. It is possible to set the intensity of the
Spiral cutting . Very low / Low intensity means that Spiral
cutting begins less often. High / Very high intensity
means that
Note:
Spiral Cutting does not start in slopes steeper
than 17%.
h / day Schedule settings
11 07:00-18:00 / 7:00
am-6:00 pm
CAUTION:
The first weeks after a new
installation, the cutting height must be set to
6 cm / 2.4 in. to prevent damage to the loop
wire. The cutting height can then be lowered
each week.
Spiral cutting . This means that the product
Spiral cutting begins more often.
2071 - 001 - 29.03.2023