Accessories; General; Security - Husqvarna AUTOMOWER 320 NERA Operator's Manual

Note:
If you change the distance for
the distance will change along the boundary wire in all
parts of the work area.

4.5 Accessories

Accessories you can change the settings of the
In
product accessories.
4.5.1 Headlights
Headlights is only available for Automower
NERA.
There are 4 different headlight settings that control when
the headlights are on:
Always on
•
• Evening only (19:00-00:00)
Evening and night (19:00-07:00)
•
Always off
•
Always on . The headlights can be
The default setting is
set to flash if there is an error.
4.5.2 To avoid collisions with the
®
Automower house
When this option is enabled, the wear on the product
®
and the Automower house is reduced, but it can result
in more uncut grass around the charging station.

4.6 General

General menu you can set the time and date, or
In the
reset to factory settings.
This menu is only available when your mobile device is
connected to the product with Bluetooth
4.6.1 Time & date
The time and date can be changed manually, or by
using the time and date from the mobile device.
4.6.2 Reset to factory settings
The user settings can be reset to factory settings.
Note:
PIN code, Loop signal, Messages and Date &
Time will not be reset.
2071 - 001 - 29.03.2023

4.7 Security

Drive Past Wire ,
The security settings controls the PIN code, the
GeoFence and other security functions. The correct PIN-
code must be entered to get access to the
menu.
This menu is only available when your mobile device is
connected to the product with Bluetooth
4.7.1 New loop signal
The loop signal is randomly selected to create a unique
link between the product and the charging station. In
®
430X/450X
rare cases, there may be a need to generate a new
signal, for instance if 2 adjacent installations have a very
similar signal.
4.7.2 Change PIN code
You can change the PIN code. Make a note of the new
PIN code in Memo. Refer to
4.7.3 Theft protection
In the
alarm duration and also what events should trigger the
alarm. The factory setting is to require PIN code and the
alarm duration is 1 min.
4.7.3.1 Require PIN code
This function means that the product cannot be operated
or controlled after the STOP button has been pushed
without first entering the correct PIN code. If the
incorrect PIN code is entered 5 times, the product is
locked for a time. The lock is extended for each new
incorrect try.
4.7.3.2 Alarm duration
There is a possibility to set how long the alarm signal
should last. A setting between 1 and 10 minutes is
possible.
4.7.3.3 STOP button pressed
If the alarm
®
.
alarm goes off if someone presses the STOP button and
the PIN code is not entered within 30 seconds.
4.7.3.4 Carried away
If the alarm
unexpected motions, and the alarm goes off.
4.7.4 GeoFence
GeoFence is a GPS-based theft protection that makes
a virtual fence for the product. If the product is more
than a set distance away from the center position the
product will be disabled and an alarm will start. The
center position sets to the current position of the product
when GeoFence is enabled. The PIN code is necessary
Introduction on page 6 .
Theft protection menu it is possible to set the
"STOP button pressed" is enabled, the
Carried away is enabled, the product senses
Security
®
.
Settings - 23