AEG BCK55636XM User Manual page 24

Before the catalytic cleaning remove all accessories.
Step 1
Select Menu / Cleaning
press three times.
Duration: 1 h.The catalytic enamel is self cleaning, do not clean it with a cloth.
11.5 How to remove and install:
Door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
Step 1 Fully open the door.
Step 2 Lift and press the clamping levers
(A) on the two door hinges.
Step 3 Close the oven door to the first opening position (approximately 70° angle). Hold the door at both
sides and pull it away from the oven at an upwards angle. Put the door with the outer side down on
a soft cloth on a stable surface.
Step 4 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
Step 5 Pull the door trim to the front to re‐
move it.
Step 6 Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
24 ENGLISH
Clean the oven with catalytic cleaning
Step 2
and When the cleaning ends the signal
sounds. The oven turns off.
When the oven is cold, clean the
oven floor with a wet soft cloth
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
A
2
B
Step 3
A
1