Advertisement
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Pozidriv screwdrivers
Wire stripper/cutter
Phillips screwdriver
Torx Screw Driver
Flat scredriver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1.
Remove front bezel panel by manually grasping left and right side of panel and pulling it out
2. Using a 1Pt pozidriv screwdriver, remove all 5 screws securing top cover to chassis.. Slighly slide back top cover to
release it from chassis. Remove cover.
3. Remove power supply by removing 4 pozidriv screws attaching power supply to back side of chasis (Use 2Pt pozidriv
screwdrive .
4. Remove 4 phillips screws (P0) on the power supply chassis and remove top plate.
5.
Using a wire cutter cut off all internal cables from power supply.
6. Remove 4 Phillips screws (using a P1 screwdrive) attaching fan to power supply chassis. Remove fan.
7.
Remove 2 phillips screws (using a P1 screwdriver) attaching power connector to power supply chassis. Remove
connector.
8.
Unscrew 4 Posidriv screws attaching Power Supply main PCA to Power Supply Chassis. Remove PCA
9.
Remove large electrolitic capacitor from Power Supply main PCA.
10. Remove Hard Disk drive assemply bracket by removing 4 Posidriv screws (1pt) attaching bracket to main chassis
11. Disconnect or cut cables going to Hard Disk Assembly
12. Remove 4 Phillips screws (use P1 screwdriver) attaching hard disk to hard disk mounting bracket. Remove Hard disk
13. Unscrew 4 Torx screws (use T-8 screw driver) attaching small PCA to bottom of Hard Disk
14. Remove 4 phillips screws (P1) from back side of main chassis attaching fan assembly to chassis. Remove additional
24 phillips screws (using P1 screwdriver) attaching all three fans to fan mounting bracket and fan screens
15. Using a 3/16" flat screwdriver, unscrew and remove 2 screws attaching large heat sink to mother board. remove heat
sink. Remove fan attached to heat sink by unscrewing 4 phillips screws. Use a P0 screwdriver. Cut wires from heatsink
to mother board.
16. Remove 4 Pozidriv screws attaching small PCA LCD assembly to the front main chassis. Access screws from the
inside of chassis. Use 1Pt screwdriver. Cut off wires. Remove PCA.
17. Remove 12 Pozidriv screws attaching mother board to chassis. Use a 2Pt screwdriver. Remove Main PCA
motherboard. Remove 8 large capacitors from mother board. Cut off or disconnect all wires going to mother
board.Remove the 2 small memory boards (PCAs).
18.
19.
20.
21.
22.
23.
24.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
1Pt, 2Pt
n/a
P0
T-8
3/16"
Page 2
Advertisement
