Haier HCP-80 Operating Instructions Manual page 23

• Pre-sterilization
Wipe up/spray disinfectant on the inner surface of the working chamber;
Disinfect the interior of the working chamber and the shelves thoroughly with disinfectant as
required by the disinfectant manufacturer.
• Washing
Use warm water and detergent solution to thoroughly remove dirt residue and sediment;
Wipe the surface with a clean cloth and water;
Drain the water in the reservoir;
Dry the surfaces of the working chamber and shelves thoroughly with a clean cloth.
• Final disinfection
Wipe up or spray disinfectant the removed shelves and air duct plate according to the
manufacturer's requirements;
Wipe up the surface of the shelves and air duct plate with a clean cloth;
Reinstall the shelves and air duct plate.
Caution Do not spray disinfectant to the air intake (at bottom of the CO
CO concentration sensor.
2
Warning Disinfection with alcohol!
a) The disinfectant of which the alcohol content is higher than 10% may form
fl ammable and explosive gas mixture when mixing with air;
b) Avoid using such disinfectants in open fl ame or high temperature environments
during disinfection;
c) Use such disinfectants in space with a good ventilation condition;
d) After completion of disinfectant reaction, wipe up the disinfected parts;
e) Follow safety regulations to avoid fi re and explosion hazards.
Caution Chlorine-containing disinfectant!
Chlorine-containing disinfectants will corrode stainless steel.
Use only disinfectants that will not corrode stainless steel.
Warning Electric shock!
Touching current-carrying parts may lead to life-threatening electric shock.
Disconnect the incubator from the power supply before cleaning and disinfecting!
a) Shut down the incubator with the power switch;
b) Unplug the power cord to avoid accidental connections;
c) Be sure that the incubator is powered off .
21
sensor) of the back
2