Table of Contents
Advertisement
quickly in green color.
5. When in any of the conditions that bat-
tery pack is too cool, or the battery
pack has not been used for a long
time, the charging lamp is lit.
In this case, charging takes longer to
fully charge the battery pack, than the
standard charging time.
If a fully charged battery pack is
inserted into the charger again, the
charging lamp light up. After several
minutes, the charging lamp may flash
quickly to indicate the charging is
completed.
6. If the charging lamp does not light
immediately after the charger is
plugged in, or if after the standard
charging time the lamp does not go
off, consult an authorized dealer.
NOTE:
When charging a cool battery pack
(below 5°C (41°F)) in a warm place,
. LAMP INDICATIONS
Green Flashing quickly
Orange Flashing
. MAINTENANCE
CAUTION: Always be sure that the tool is switched off and the battery pack is
removed before attempting to perform inspection or maintenance.
Keep your Reciprocating saw clean for good cutting performance and to help keep it
safe to use.
Wipe the reciprocating saw with a dry, soft cloth. Do not use a wet cloth or cleaning liq-
uids. They could damage the reciprocating saw's finish.
Be sure to rub off any oil or grease which could make the tool slippery or hard to handle.
BATTERY RECYCLING
ATTENTION:
FOR Ni-MH Battery Pack, EY9251
A nickel metal hydride battery that is recyclable powers the product you have pur-
chased.
Red Flashing
Red Lit
Orange Lit
leave the battery pack at the place
and wait for more than one hour to
warm up the battery to the level of
the ambient temperature. Other-
wise battery pack may not be fully
charged.
Cool down the charger when
charging more than two battery
packs consecutively.
Do not insert your fingers into con-
tact hole, when holding charger or
any other occasions.
CAUTION:
• Do not use power source from an
engine generator.
This can damage the charger and
present the risk of fire or personal
injury.
• Do not cover vent holes on the
charger and the battery pack..
Charger is plugged into the AC outlet.
Ready to charge.
Now charging
Charging is completed.
Battery pack is warm. Charging will begin
when temperature of battery pack drops.
Charging is not possible. Clogged with
dust or malfunction of the battery pack.
- 10 -
Advertisement
Table of Contents
