Cutting Depth Adjustment - Panasonic EY-3551 Operating Instructions Manual

Cutting depth adjustment

•Remove battery pack.
•Loosen the depth adjustment lever by pushing it
and adjust the cutting depth.(See Fig.5)
Tighten the depth adjustment lever securely by
lifting it up towards the motor housing at the
desired cutting depth.
When material is 10mm (3/8") or less thick, adjust
the cutting depth so that the blade protrudes
approx. 5mm (3/16") from the bottom of material
Tighten
1
2
Loosen
Depth adjustment lever
Fig. 5
Bevel cutting adjustment
•Remove battery pack.
•To adjust the bevel of cut setting, loose the
bevel adjusting knob. Turn the bevel adjusting
knob counterclockwise.(See Fig.6) Adjust the
bevel of cut.
To set the bevel of cut at 90 degree, use a trian-
gle. To have fine bevel adjustment, use the bevel
adjustment screw on the base. (See Fig.7)
•Tighten the bevel adjusting knob securely.
Fig. 6
Fig. 7
Tighten
Loosen
Bevel adjustment screw
- 11 -
Rip fence (EY3500B7727)
(Available as an optional accessory, not included)
Rip fence is convenient for rip cuts and repeated
cuts of same width.
•Remove battery pack.
•Insert rip fence and adjust cutting width. (See fig. 8)
•Fasten screw securely to fix rip fence.
2
Fasten knob
1Insert and adjust
Fig. 8
Rip Fence