Care And Cleaning; Inner Pot - Sharp HEALSIO KN-H24XA Operation Manual

Table of Contents

Advertisement

Available languages

Available languages

CARE AND CLEANING

Before cleaning, turn the appliance off. Unplug and then remove the inlet plug from the main unit.
Make sure the cavity including the temperature sensor and thermo plate, each parts and
accessories are completely cool.
NOTE :
Do not use commercial cleaners, abrasive, harsh cleaners, solutions that contain sodium
hydroxide, or scouring pads on any part of the appliance. Dishwashers cannot be used to clean
the appliance.
Inner pot/Drip tray
Clean after every use.
Remove the drip tray after taking the inner pot out.
Wash with mild soap or detergent solution using a soft sponge. Rinse and dry thoroughly.
 Water may leave trace minerals, which make it easier for iridescent or white
discoloration to form. Water may also cause rusting.
Cleaning tips
Rinse carefully after washing
Heavy dirt
Iridescent or white
discoloration
When the pot has
become rusty
*Use citric acid that is generally available in pharmacies etc. (without additives or over 99.5%).
Lemon juice can be used instead of citric acid.
NOTE :
Do not wash the outside or the inside water
level mark with cream cleanser with or even
without a soft sponge.
If the handle becomes loose
Do not use the pot if the handle is loose. There is a risk of the pot falling
and causing burns. Tighten the screws on the under side of the handle before use.
Soak with hot water and rub with a sponge.
Baking soda can be used for stubborn stain.
Put 10g of baking soda per 200mL of water in the inner pot, and set the appliance
with MANUAL [1-2] for 10 minutes.
After heating, leave the inner pot for a few hours. Then rub with a soft sponge.
(Be careful not to get burned with the hot water after heating)
These are caused by elements contained in water and are not harmful to humans.
You can use the pot as it is.
If it bothers you, mix 1 teaspoon of citric acid with 1 tablespoon of water, apply
on a soft sponge and rub.
Mix 1 teaspoon of citric acid and a little salt with 1 tablespoon of water, apply on
a soft sponge and rub. Rust can be dif cult or impossible to remove completely.
Key Point - Clean immediately if it is dirty!
*
*
Screws
en-16
Water level mark
Outside

Advertisement

Table of Contents
loading

Table of Contents