Canon Inner Finisher-L1 Service Manual page 109

■ Adjusting the Alignment Position at Non-staple Mode
< Use case >
• When the trailing edge of paper stack is left to the delivery mouth at the delivery, at the non-sort mode or shift-sort mode.
• When the paper stack is delivered to the position where the paper retainer does not reach the paper stack at the delivery,
at the non-sort mode or shift-sort mode.
< Procedure of adjustment >
NOTE:
After the setting value is changed, write the changed value in the service label.
1. Adjust the width of the Alignment Plate by the following service mode.
• SORTER > ADJUST > INF-ALG4
Adjustment range: -50 to 50 (Unit: 0.1mm)
As the value is incremented by 1, the width of the Alignment Plates becomes narrow by 0.1 mm.
+: When the paper stack is delivered to the position where the paper retainer does not reach the paper stack at the delivery,
increase values
-: When the trailing edge of paper stack is left to the delivery mouth at the delivery, decrease values
■ Adjusting the Return Belt Pressure
< Use case >
• When misalignment occurs in feed direction.
< Procedure of adjustment >
NOTE:
After the setting value is changed, write the changed value in the service label.
Feed Direction
Feed Direction
102
Feed Direction
Feed Direction
5. Adjustment