Pioneer CDJ-900 Service Manual page 47

5
4 Factory reset
BROWSE_FL
DATA_FL
BROWSE_FL
DATA_FL
5 Drive operation / error rate measurement
BROWSE_FL
DATA_FL
6 A check of auto standby
BROWSE_FL
DATA_FL
5
6
It is used to return the contents set up by UTILITY to a factory-shipments state,
or clear an error history.
If TIME MODE button is pushed on this screen, it will return to the following states.
<<UTILITY>>
• PLAYER NO = AUTO
• AUTO CUE LEVEL = -60 dB
• AUTO STANDBY = ON
• LIBRARY CREATOR = LIBRARY
• HISTORY NAME = "HISTORY"
• MIDI Ch = 1
• DIGITAL OUT = 24 bit
• SLIP FLASHING = ON
• QUANTIZE = OFF
<<The state of a key>>
• TIME MODE = REMAIN
• AUTO CUE = OFF
• JOG MODE = CDJ
<<Error history>>
• ALL CLEAR
Switching on a power supply can also perform, pushing a USB-STOP button
and EJECT button simultaneously, in order to perform Factory reset.
However, an error history is not cleared at this time.
The state of the drive at the time of servo test operation
and the measurement result of an error rate are displayed.
Refer to "[5] Confirmation of movement of a drive unit" for the details of operation.
Usually, there are no media to reproduce, and when prolonged operation is not
performed, it shifts to the auto standby mode.
However, in this mode, it can shift to the auto standby mode immediately.
-> Push the TEMPO button.
If operation excluding the following from the state of being in the auto standby
mode is performed,
• Push the USB STOP button
• JOG rotation (except for touching the Table top)
• Turn the VINYL SPEED ADJUST VOLUME
• Move the TEMPO slider
It will return from the auto standby mode.
Since a return is the same processing as power supply ON, the service mode is
ended.
CDJ-900
6
7
7
8
A
B
C
D
E
F
47
8