Operation
Top line
Middle line
Bottom line
Top line
Middle line
Bottom line
58
Programme sequence indicator
After the programme has started the programme sequence can be
followed in the three-line display
– Programme name.
The following parameters can be checked using the arrow buttons
and :
– Current programme block, e.g.
– Actual or required temperature
(depending on the display set, see "Further settings / Display:
Temperature").
– Cycle number
– Time left (in hours; under an hour, in minutes)
At the end of the programme
A programme is usually finished when the following parameters and
messages are shown in the display:
– Programme name.
Continuously alternating between:
– (Parameter met/not met)
– Cycle number
– Programme finished
The LED in the Start/Stop button also goes out. In the factory default
state an acoustic tone also sounds for approx. 10 seconds (see
"Settings / Volume").
Short
Main wash 1
Time left
15
Main wash 1
Min
,