Preparing The Machine For First Use; Installing The Handle; Installing The Discharge Chute - Toro Power Clear 518ZR Operator's Manual

1. Warning—read the Operator's Start Guide and the Operator's
Manual.
2. Cutting/dismemberment hazard, impeller—stop the engine
before leaving the machine.
3. Thrown object hazard—keep bystanders a safe distance from
the machine.
Preparing the Machine
for First Use

Installing the Handle

1. Position the ends of the upper handle on the inside of
the lower handle and align the holes.
2. Insert the oval-head bolts into the aligned holes, with
the bolt heads on the outside of the handle
1. Oval-head bolt (2)
3. Install the curved washers and the handle knobs on the
oval-head bolts on the inside of the handle
and tighten the knobs securely.
Important: Ensure that the cable is routed to the
outside of the handle.
(Figure
Figure 4
2. Curved washers and
handle knobs
(Figure
117-7713
4. Fuel spill hazard—do not tip machine forward or backward.
5. To engage the auger, squeeze the control bar.
6. Release the control bar to disengage the auger.

Installing the Discharge Chute

Install the discharge chute as shown in
4).
1. Knob
Note: Install the bolts from the inside of discharge chute so
that the washers and locknuts are on the outside of the chute.
Important: Do not overtighten the locknuts.
4)
3
Figure 5.
Figure 5
2. Bolt (2), washer (2), and
locknut (2)