Table Of Contents; Safety; Safety And Instructional Decals - Toro Power Clear 518ZR Operator's Manual

Contents
Introduction .................................................................. 1
Safety ............................................................................ 2
Safety and Instructional Decals ................................. 2
Preparing the Machine for First Use .................................. 3
Installing the Handle................................................ 3
Installing the Discharge Chute................................... 3
Filling the Engine with Oil ........................................ 4
Adjusting the Control Cable...................................... 4
Filling the Fuel Tank ................................................ 5
Starting the Engine .................................................. 6
............................................................................. 7

Safety and Instructional Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
1. Cutting dismemberment, impeller and cutting
dismemberment, auger hazards-do not place your hand in
the chute; remove the ignition key and read the instructions
before servicing or performing maintenance.
117-6047

Safety

This machine meets or exceeds the B71.3 specifications
of the American National Standards Institute in effect
at the time of production.
•
Read and understand the contents of the operator's start
guide before you start the engine. Make sure everyone
using this product knows how to use the product and
understands the warnings.
•
Do not put hands or feet near moving components on
the machine.
•
Do not operate machine without all guards and other
safety protective devices in place and working on the
machine.
•
Keep clear of any discharge opening. Keep bystanders a
safe distance from the machine.
•
Keep children out of the operating area and under the
watchful care of a responsible adult other than the
operator. Never allow children to operate the machine.
•
Shut the machine off before unclogging, servicing, or
fueling.
1. Primer
2. Push the primer two times
to prime the engine.
3. Push key in to switch
engine On.
2
120-0149
4. Pull key to switch engine
switch Off.
5. Remove key to lock
machine.
6. Read the Operator's
Manual before checking
engine oil level.