Advertisement
4. ASSEMBLY
4.1.
Please note that the two wheels are assembled to the axle differently. The left hand wheel (as seen from the handle side of the
hopper) is free wheeling. The right hand wheel drives the blades within the hopper. Referring to fig.1 assemble the left hand wheel
first by sliding a Ø12mm flat washer (11) onto the axle followed by a bushing (5). Slide a wheel (15) over the bushing followed by
another Ø12mm flat washer (11). Insert the smaller split pin Ø3mm x 30 (7) through the holes in the end of the axle and retain the
assembly by bending it over.
4.2.
Slide another washer (11) and bushing (5) over the axle on the other side of the hopper ensuring that the holes in the bushing are
adjacent to the side of the hopper. Slide the other wheel over the bushing and align the holes in the inner hub of the wheel with the
holes in the bushing and the hole through the axle. Retain this assembly by inserting the larger split pin Ø5mm x 45 (8) through all
three components. Retain the assembly by bending over the split pin.
4.3.
Referring to fig.2 take two M6 x 35mm bolts (2) and drop two Ø6mm washers (12) onto them. Align one leg (14) with the holes in the
hopper and insert the bolts through the hopper and the leg. Screw a wing nut (10) onto each bolt and tighten them up to draw the leg
firmly up against the hopper. Attach the other leg to the hopper in the same way. See fig.3.
4.4.
Referring to fig.4, assemble a connecting tube (19) to each leg using an M6 x 35mm hex headed bolt (2) and an M6 Wing nut (10).
Firmly tighten each nut as shown in fig.5.
4.5.
Referring to fig.6, push the handle onto the connecting tubes and fix in place using an M6 x 30mm bolt (1) and an M6 Wing nut (10) at
each connection. Firmly tighten each wing nut.
4.6.
Referring to fig.6, insert the bent end of the control cable through the hole at the bottom of the index plate lever and then attach the
index plate assembly to the right hand side of the handle using an M6 x 30mm bolt (1) together with the existing M6 lock nut (9) and
wing nut (10) used to mount the handle (18).
4.7.
Attach the cable clamp mounting plate (17) to the connecting tube just below the index plate assembly using one M6 x 30mm
bolt (1) with an M6 lock nut (9) as shown in fig.7. Lay the control cable onto the mounting plate between the screw holes
and lay the cable clamp (20) over the cable and clamp it lightly in place using two M5 x 10 screws (3) and two M5 locknuts (6).
4.8.
Referring to fig.8, push the index plate lever to the bottom of its travel and make sure that the distribution slots on the
underside of the hopper are not covered by the rotating shutter. Now fully tighten the cable clamp.
4.9.
Test the action of the lever to ensure that the rotating shutter successfully exposes and hides the distribution slots.
4.10.
When the required distribution rate is achieved, the stop and wing nut fitted in the lever slot can be brought up to the bottom of the
lever to fix its position. See fig.8.
fig.7
© Jack Sealey Limited
fig.1
fig.2
fig.4
fig.8
Original Language Version
fig.5
SPD37W Issue 3 (H,2,3,F)
fig.3
fig.6
04/05/23
Advertisement
