Hitachi RPC-1.5FSR Technical Catalogue page 21

z Descriptions of Motion Sensor Control Condition
Condition
MENU
on Wired "If Absent"
Controller
Adjusting
Value of
Temperature
Setting
Indoor Unit Air Flow
Volume
Air Flow
Direction
: The operation will be stopped by the wired controller PC-ARF1 when all the indoor units with the
*1)
motion sensors switch to "MODE 3". If the operation is stopped by the wired controller PC-ARF1,
it will not restart even if the motion sensor detects the human motion. The indoor unit without the
motion sensor and the indoor unit with the motion sensor can be mixed. In this case, the indoor
unit without the motion sensor will also be stopped by the wired controller PC-ARF1 as shown in the
*2)
figure below .
In the case of the motion sensor setting "If Absent: OFF" is
set by the wired controller.
Indoor Unit A
(with Motion Sensor Kit)
On Motion Sensor Control
[Mode 3]
Operation Stop
Wired Controller
(PC-ARF1)
TCI-20007-rev.1
[Standard
[MODE 1]
Operation]
- -
Adjusting Adjusting
o o
0 C 1 C
Setting
Setting
Air Flow
Air Flow
Volume-1
Volume
(Min: Low)
Set
Air Flow Horizontal
Direction
Indoor Unit B
(with Motion Sensor Kit)
Transmission Wire
for H-LINK ll
Transmission Wire
for Wired Controller
On Motion Sensor Control
[MODE 2]
Running
-
Operation
Adjusting
o
2 C
Setting
Air Flow
Volume-1
(Min: Low)
Horizontal
[Mode 3]
Operation Stop
FEATURES
[MODE 3]
*1)
Standby Stop
Forced
Thermo-
OFF
[Mode3]
Same
Slo Condition
as Standby
Horizontal
Indoor Unit C
(without Motion Sensor Kit)
Operation Stop *2)
1-11