Husqvarna 1-10DPS75 Operator's Manual page 13

To adjust the height of the magnetic
seals
The correct height adjustment of the magnetic seals is
8-10 mm from the surface.
1. Loosen the 2 adjustment screws at the front to set
the correct height.
2. Loosen the 2 adjustment screws at the rear to set
the correct height.
3. Tighten the screws.
To adjust the height of the brush list
seals
The correct height adjustment of the brush lists is 1 mm
from the surface.
2014 - 002 - 06.04.2023
1. Loosen the 4 screws that holds the brush list.
2. Adjust the height of the brush list.
3. Tighten the 4 screws.
Abrasive
Speak to your Husqvarna dealer for the selection of
correct abrasive for your surface operation. Refer to
Approved abrasive on page 29 .
13