Troubleshooting
Fault
Nothing happens after the Industrial
PC has been switched on
The Industrial PC does not boot
fully
Computer boots, software starts,
but control does not operate
correctly
Floppy disk or CD access error
The Industrial PC functions only
partially or only part of the time, e.g.
no or dark picture, but disk drive
responds when switching on
C6240
Please also refer to chapter
Fault correction
Cause
No power supply to the Industrial
PC.
Other cause.
Floppy disk or CD in the drive.
Setup settings are incorrect.
Other cause.
Cause of the fault is either in the
software or in parts of the plant
outside the Industrial PC.
Faulty disk or CD.
Faulty disk drive.
Defective components in the
Industrial PC.
General
instructions.
Procedure
Check power supply cable.
Call Beckhoff Service.
Remove floppy disk or CD
and press any key.
Check the setup settings.
Call Beckhoff Service.
Call the manufacturer of the
machine or the software.
Check disk or CD in another
drive.
Call Beckhoff Service.
Call Beckhoff Service.
Troubleshooting
17