Pioneer PRO-110FD Service Manual page 156

1
A
MAIN Assy
1
Disconnect cables, connectors, as required.
2
Remove the two screws.
3
Remove the two screws.
4
Remove the POD cover.
5
Remove the POD stay A with PCB.
How to remove the bridge connector
connecting between the MAIN and
B
TANSHI Assys
(1) Grip the two short edges of the connector with
longnose pliers.
(2) Insert a finger between the longnose pliers and
the board to protect the board and the mounted
parts on the board from accidental damage by
the pliers then, using your finger as a fulcrum and
the pliers as a lever, pry the connector upward to
remove it.
C
TANSHI Assy
Terminal Panel B (50U)
3
1
Remove the four screws.
2
D
Remove the two screws.
3
Remove the 10 screws.
4
Remove the four screws.
5
Remove the terminal panel B (50U).
Note:
The wiring shown in the photo is different from
the actual wiring, because the product in the
E
photo is a prototype.
Upon servicing, be sure to restore the original
wiring of the unit after repair work.
Tightening sequence for the screws when assembling
When assembling the terminal panel B (50U), tighten
the screws in the following sequence:
1
Tighten the screw.
2
Tighten the screw.
F
3
Tighten other screws.
116
1
2
MAIN Assy
3
3
3
PDP-5010FD
2
3
2
POD stay A
3
TANSHI Assy
3
1
×4
2 2
4 4
TANSHI Assy
1
3
4
2 POD Assy
5
3
4
POD cover
MAIN Assy
3 3 3
5
4
Terminal panel B (50U)
Terminal panel A (U)
2
4
3
3
3
4