Qsi (Input Signal Data); Drv (Panel Drive-Power On / Off) - Pioneer PRO-110FD Service Manual

5

9.3.12 QSI (INPUT SIGNAL DATA)

The command QSI is for acquiring all data on input video signals.
Command Effective Operation
Format Modes
[QSI] All operations
Data Arrangement
ECO
1 Type of drive sequence
2 Standard/nonstandard
3 Type of ABL/WB tables
4 Total value of PCN
5 Total value of PRH
6 Total value of PGH
7 Total value of PBH
8 Total value of PBR
9 Total value of PRL
10 Total value of PGL
11 Total value of PBL
12 Total value of ABL
13 V frequency distinction
14 Reserved
15 Reserved
16 APL acquiring data
17 Number of SUS pulses
18 Result of detection of still picture
19 Result of detection of cracking in the panel
20 Result of detection for scanning protection
21 Result of detection for external protection
22 Transition of protection operation
23 Reserved
24
CS

9.3.13 DRV (PANEL DRIVE-POWER ON / OFF)

Drive ON/OFF: ON/OFF control of panel drive-power system
Command Effective Operation
Format Modes
[DRV+S00] Every time
[DRV+S01] Every time
Once the DRIVE OFF command is accepted, DRIVE OFF cannot be canceled by pressing the DRIVE OFF key again or by
turning the unit off then back on with the STANDBY OFF/ON key.
To cancel DRIVE OFF, restart the unit by unplugging then again plugging in the power cord.
5
6
Function
To acquire all data on input video signals
Output
Data
Example
Length
3 Byte QSI (fixed)
3 Byte 60V
1 Byte S
2 Byte T1
4 Byte 0256
4 Byte 0256
4 Byte 0256
4 Byte 0256
4 Byte 0512
4 Byte 0512
4 Byte 0512
4 Byte 0512
3 Byte 128
4 Byte 6002
∗
1 Byte
∗∗∗∗
4 Byte
4 Byte 1023
4 Byte 0457
1 Byte 1
1 Byte 1
1 Byte 1
1 Byte 1
1 Byte 1
∗∗∗∗
4 Byte
2 Byte 27
Function
DRIVE OFF
DRIVE ON (default)
PDP-5010FD
6
7
Remarks
Return data: 3 (ECO) + 66 (DATA) + 2 (CS) = 71 Byte
1: Type of Drive 3: Type of ABL/WB
sequence
Tn
50V Video 50 Hz
60V Video 60 Hz
13: V frequency
72V Video 72 Hz
75V Video 75 Hz
Reading value *100
60P PC 60 Hz
16: APL acquiring
70P PC 70 Hz
2: Standard/
Output with 10 bit 0 to 1023
nonstandard
S Standard
17: Number of SUS
N Nonstandard
0174 to 2752
18 to 21: Each protection function
0 Setting: OFF
1 Setting: ON (during wait)
2 Setting: ON (during operation)
22: Transition of protection
operations
0 Upper limit state for brightness
1 Brightness being reduced
2 Lower limit state for brightness
3 Brightness being increased
Remarks
7
8
A
tables
n: 1 to 4
distinction
B
data
pulses
C
D
E
F
165
8