Checking The Engine Oil Level; Adjusting The Cutting Height - Toro 250000001 Operator's Manual

Checking the Engine Oil Level

1. Remove the dipstick, wipe it clean, and fully
install the dipstick.
m-8098

Adjusting the Cutting Height

Adjusting the cutting height may bring you into contact with the moving blade, causing
serious injury.
S
Stop the engine and wait for all moving parts to stop.
S
Do not put your fingers under the housing when adjusting the cutting height.
If the engine has been running, the muffler will be hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height
as desired. Set all four
wheels to the same
height.
Note: To raise the mower,
move all 4 cutting height
levers forward; to lower
the mower, move them all
rearward.
8
2. Remove the dipstick and check the oil level. If the
oil level is below the Add mark on the dipstick,
slowly pour oil into the oil fill tube to raise the oil level
to the Full mark on the dipstick. Do not overfill.
(Max. fill: 20 oz., type: SAE 30W detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or
higher.)
3. Install the dipstick.
m-8099/m-5571
Warning
Caution
m-8098
A= 1-1/4 inch (3 cm)
B= 1-3/4 inch (4 cm)
C= 2-1/4 inch (6 cm)
D= 2-3/4 inch (7 cm)
3352-856 Rev B
m-5629a
E= 3-1/4 inch (8 cm)
F= 3-3/4 inch (10 cm)
G= 4-1/4 inch (11 cm)
m-8100