Adjusting The Handle Height; Operation; Starting The Engine - Toro 250000001 Operator's Manual

Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
1. Remove the
lower handle knobs
and lock washers
that attach the
handle brackets to
the lower handle
ends.
m-8097
2. Insert the bolt
through the hole in each
of the handle brackets
that sets the handle to
the desired position.
Note: A is the
highest position; B
(either hole) is the
middle position; and
C is the lowest
position.
3. Install the lock
washers and lower
handle knobs, and
tighten the knobs as
tight as you can by
hand.
Note: Insert the lock
washer between the
bracket and the
knob.
A
B
C
m-8101
m-8097
3352-856 Rev B
9

Operation

Starting the Engine

1. Push the
ignition toggle
switch to the On
("I") position.
2. Firmly push in
the primer 3 times
with your thumb,
holding the primer
in for a second
before releasing it
each time.
Note: If the air
temperature is
° °
below 55 F (13 C),
firmly push the
primer in 5 times.
3. Start the engine in one of two ways:
Pull the recoil
•
starter in the
operating
position.
Pull the recoil
•
starter at the
engine.
4. If the mower does not start in 1 or 2 pulls, press
the primer button 1 or 2 times and try starting it again.
Note: If the mower still does not start, contact an
Authorized Service Dealer.
m-8203
m-7311
m-8208
m-?