Philips AZ215 Short User Manual

www.philips.com/support
Question?
Contact
Philips
Short User Manual
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of Gibson
Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.
and are used under license from Koninklijke Philips N.V.
AZ215_AZ216_05_Short User Manual_V1.0
All manuals and user guides at all-guides.com
1 Safety
AZ215
AZ216
This 'bolt of lightning' indicates uninsulated material within your unit
may cause an electrical shock. For the safety of everyone in your
household, please do not remove product covering.
The 'exclamation point' calls attention to features for which you
should read the enclosed literature closely to prevent operating and
maintenance problems.
WARNING: To reduce the risk of fire or electric shock, this
apparatus should not be exposed to rain or moisture and objects
filled with liquids, such as vases, should not be placed on this
apparatus.
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot, fully insert.
Warning
•
Never remove the casing of this apparatus.
•
Never lubricate any part of this apparatus.
•
Never look into the laser beam inside this apparatus.
•
Never place this apparatus on other electrical equipment.
•
Keep this apparatus away from direct sunlight, naked flames or heat.
•
Ensure that you always have easy access to the power cord, plug or
adaptor to disconnect the apparatus from the power.
•
The device shall not exposed to dripping or splashing.
• Do no place any source of danger on the device (e.g. liquid
filled objects. lit candles).
• Where the MAINS plug or an appliance coupler is used as
the disconnect device, the disconnect device shall remain
readily operable.
•
Make sure that there is enough free space around the
product for ventilation.
•
Battery usage CAUTION – To prevent battery leakage which
may result in bodily injury, property damage, or damage to
the unit:
• Install all batteries correctly, + and - as marked on the
unit.
• Batteries (packed or installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
• Remove batteries when the unit is not used for a long
time.
• Only use attachments/accessories specified by the
manufacturer.
Caution
• Use of controls or adjustments or performance of procedures other than
herein may result in hazardous laser exposure or other unsafe operation.
2 Notice
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead - not simply over the two
wires.
Any changes or modifications made to this device that are not
Copyright in the U.K.
expressly approved by Gibson Innovations may void the user's
Recording and playback of material may require consent. see
authority to operate the equipment.
Copyright Act 1956 and The performer's Protection Acts 1958 to
1972.
This apparatus includes these labels:
This product complies with the radio interference requirements of
the European Community.
Disposal of your old product
Class II equipment symbol
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
This symbol indicates that the apparatus has a double insulation
system.
This symbol on a product means that the product is covered by
European Directive 2012/19/EU. Inform yourself about the local
Note
separate collection system for electrical and electronic products.
Follow local rules and never dispose of the product with normal
•
The type plate is located on the bottom of the apparatus.
household waste. Correct disposal of old products helps prevent
negative consequences for the environment and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to
make the packaging easy to separate into three materials: cardboard
(box), paper pulp (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
Specifications
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
Amplifier
Important notes for users in the U.K.
Rated Output Power
This information applies only to products with a UK mains plug. Frequency Response
This product is fitted with an approved molded plug. If you replace
Signal to Noise Ratio
the fuse, use one with:
Total Harmonic Distortion
• the ratings shown on the plug,
• a BS 1362 approval, and
Disc
• the ASTA approval mark.
Audio DAC
Contact your dealer if you are not sure about what type of fuse
to use. Frequency Response
Caution: To conform with the EMC directive (2004/108/EC), do not
Tuner
detach the plug from the power cord.
How to connect a plug
Tuning Range
The wires in the mains lead are coloured with the following code:
Tunning grid
blue = neutral (N), brown = live (L).
Preset stations
As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as follows:
• Connect the blue wire to the terminal marked N or coloured
black.
• Connect the brown wire to the terminal marked L or
coloured red.
• Do not connect either wire to the earth terminal in the plug,
marked E (or e) or coloured green (or green and yellow).
General
3W
Power supply
80 Hz - 16000 Hz, +/-3 dB
- AC Power 220 - 240 V ~, 50/60 Hz
>72 dBA
- Battery DC 9V, 6 x 1.5 V R14/
UM2/C Cell
<1 %
Standby Power Consumption < 0.5 W
Dimensions
24 Bits, 44.1 kHz
- Main Unit (W x H x D) 252 x 124 x 232 mm
80 Hz -16000Hz, +/-3 dB
Weight
- Main Unit 1.0 kg
- With Packing 1.6kg
FM: 87.5 - 108 MHz
50 KHz
20