Contact Distributor - Hitachi RPC-5.0FSR Operation Manual

14.3 Contact Distributor
If the problem is not resolved even after checking the previous items or if other troubles not mentioned in the
previous pages occur, stop using the product and contact your distributor or contractor.
If abnormality (burnt odor, etc.) occurs, stop the operation and turn OFF the main power source
immediately. If not, it may cause breakage of the product, an electric shock or a fire.
Contact your distributor or contractor.
Protection devices (fuses, breakers, and ELB's) activate
frequently or the operation switch does not work.
Water leakage from the indoor unit.
"Motion Sensor ON" is flashing.
● The RUN indicator (red) is flashing.
● The indoor unit number, alarm code, unit model
code, and the number of connected indoor units are
displayed on LCD.
● If multiple indoor units are connected to one controller,
the above abnormality informations for each indoor
unit are displayed individually.
Check the details on LCD and contact your distributor.
Alarm Code:
MODEL : F .08
I.U. : RCI-3.0FSN3
IDU : ******
ODU : ******
O.U. : RAS-3HVRNM2
Sel.
Provide the following information when contacting your distributor.
1) Unit Model
2) Content of Trouble
3) Alarm Code No. on LCD or Details of a Flashing Indicator
A10762290A
WARNING
Trouble
Indoor Unit Number
01-02
23
Chek
AlarmRST
Address
OP MODE Entr
OK
Action before Contact
Turn OFF the power supply.
Stop the operation.
There is a possibility of the failure of motion sensor.
Make the setting of motion sensor and "Floor HEAT
Control" invalid and contact your distributor. In that
case, after the LCD of wired controller display has
disappeared and until service is finished, the operation
of this unit is available.
Refer to the item 14.4, the alarm code table.
Contact your distributor and inform them of the alarm
code indicated on the LCD of the wired controller.
21