Download Print this page

Panasonic ET-LAD320P Operating Instructions Manual page 3

Replacement lamp unit

Advertisement

Before replacing the lamp unit
z Make sure to turn off the power before replacing the
lamp unit.
z When switching off the projector, make sure
to follow the procedures in "Switching off the
projector" (
page 3).
■ Checking the lamp unit to be
replaced
Check the status of the lamp
indicators <LAMP1>/<LAMP2>.
z The lamp unit corresponding to the lamp indicator
that is lit in red is required to be replaced.
Main unit operating part
Power standby
<  > button
<MAIN POWER> switch
Attention
z Panasonic Connect Co., Ltd. shall not be
responsible for damages or malfunctioning of the
product due to the use of other than a Panasonic
Connect Co., Ltd. lamp unit. Use only specified
lamp units.
z Do not use replacement lamp units (for portrait
mode) and normal lamp units together. Check
the product number on the label attached to the
replacement lamp unit.
z A replacement lamp unit (for portrait mode) must
be used when installing in a portrait orientation.
z Do not install the projector in any orientation other
than portrait when using a replacement lamp unit
(for portrait mode).
z Since the luminous lamp is made of glass, it may
burst if dropped or hit with a hard object. Please
handle with care.
z Do not disassemble or modify the lamp unit.
z When replacing the lamp unit, be sure to hold it
by the handle because its surface is pointed and
its shape is protruded.
z The lamp may be burst. Replace the lamp unit
carefully so that the broken pieces of the lamp
glass will not scatter.
<Power indicator>
(ON (G) / STANDBY (R) )
<Lamp indicator>
(LAMP1, LAMP2)
z The lamp contains mercury. When disposing of
used lamp units, contact your local authorities or
dealer for correct methods of disposal.
z Panasonic Connect Co., Ltd. recommends
that the lamp unit be replaced by a specialized
engineer. Contact your dealer.
Note
z A Phillips screwdriver is necessary when
replacing the lamp unit.
z The Multi Projector Monitoring & Control Software
in the CD-ROM supplied with the PT-DZ13K
series may not support the Model No. display of
the replacement lamp unit (for portrait mode).
Download the latest version of the software from
"Multi Projector Monitoring & Control Software" on
the website (https://panasonic.net/cns/projector/).
Switching off the projector
When the projector is operating, perform the follow-
ing steps to turn off the projector, and wait until the
lamp unit cools off then make the replacement.
1) Press the power standby <
button.
2) Press ◀▶ to select [OK], and
press the <ENTER> button.
(Or press the power standby <
button again.)
z Projection of the image will stop, and the
power indicator <ON (G)/STANDBY (R)> on
the projector lights in orange.
(The fan keeps running.)
3) Wait until the power indicator
<ON (G)/STANDBY (R)> of the
projector lights in red (and the
fan stops) for approximately 170
seconds.
4) Press the <OFF> side of the <MAIN
POWER> switch to turn off the
power.
>
>
ENGLISH-3

Advertisement

loading

This manual is also suitable for:

Et-lad320pwEt-lad320aEt-lad320aw