Connector Board - HP EliteBook 1040 Maintenance And Service Manual

3. Remove the connector board cable from the computer (3).
To install the connector board cable, reverse this procedure.

Connector board

To remove the connector board, use this procedure and illustration.
Table 5-9 Connector board description and part number
Description
Connector board (includes USB port and microSD slot)
NOTE: The connector board spare part kit does not include the connector board cable. The
connector board cable is included in the Cable Kit, spare part number N09040-001.
Before removing the connector board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the connector board:
1. Remove the three Phillips M2.0 × 2.5 screws (1) that secure the cable retainer and the I/O bracket to
the computer.
2. Remove the cable retainer (2) and the I/O bracket (3) from the computer.
The cable retainer and the I/O bracket are included in the Bracket Kit, spare part number
N09030-001.
52 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 38).
Spare part number
N09042-001
Battery on page 40).
38).