Husqvarna 1-10DS Operator's Manual page 28

Hide thumbs Also See for 1-10DS:
Table of Contents

Advertisement

Available languages

Available languages

To set the product in transport position
WARNING:
is on a horizontal surface before you lift or
lower the product.
WARNING:
the blastwheels have fully stopped.
1. Attach the lever to the lift mechanism (A).
A
C
2. Lift (B) the lever to transportation position (C).
To move the product manually
WARNING:
are stationary before you move the product.
WARNING:
steel toe-cap and non-slip sole.
WARNING:
up and down ramps manually with the drive
system disengaged. Only move the product
manually on level ground.
1. Disengage the drive system. Refer to
disengage the drive system on page 12 .
2. Push the handle downwards.
3. Push or pull the product by the handle.
4. Engage the drive system. Refer to
operate the product on page 12 . With the motor off,
this has the function of a parking brake and prevents
accidental movement of the product.
28
Make sure that the product
Do not lift the product until
B
Wait until all moving parts
Use protective boots with
Do not move the product
To engage and
To do before you
To move the product with the drive
system
WARNING:
there is a risk of injury if the product falls. Be
careful when you move around the product.
WARNING:
the ground during operation.
WARNING:
forward during operation.
WARNING:
steel toe-cap and non-slip sole.
1. Engage the drive system. Refer to
disengage the drive system on page 12 .
2. Pull down the handle to lift the product from the
surface.
3. Set and adjust the movement speed with the speed
control dial (C).
A
4. Push and hold the drive system lever (D) to move
the product rearward.
The product is heavy and
Do not lift the product of
Do not move the product
Use protective boots with
To engage and
B
C
D
2070 - 003 - 16.03.2023

Advertisement

Table of Contents
loading

This manual is also suitable for:

1-15ds

Table of Contents