Bosch HGS8045UC-CL Installation Manual page 20

Remove the nozzle D and replace it with an
3.
appropriate nozzle for the new type of gas.
Small burner/large burner
Dual-flame burner
Place the burner cup B onto the burner C and place
4.
the burner cover A onto the burner cup B.
Refit the grates.
5.
20
Setting the minimum gas flow
Remove the control knob and knob ring.
1.
Turn the inner setting screw clockwise gently until it
2.
bottoms out.
Note: In case of conversion from propane gas to
natural gas, turn out all bypass nozzles for 1/2 turn.
Small burner/large burner
Dual-flame burner:
Replace the control knobs.
3.
Light each burner individually and check for flame
4.
stability on low setting.
If required, loosen the setting screw to increase the
5.
gas flow.
Ensure that the flame does not go out when the gas
6.
flow is quickly changed between maximum and
minimum, and vice versa. The optimum setting is
achieved when the height of the small flame is
approx. 1/8" (3 to 4 mm).
Refit the control knob and knob ring for the gas
7.
burner.
Repeat steps 2 to 8 until all of the gas burners have
8.
been set.
Connect the appliance to the power supply.
9.