Table of Contents
Advertisement
2.2
Intel(R) Ethernet Flash Firmware Utility
The Intel(R) Ethernet Flash Firmware Utility allows you to switch between PXE option ROM
and iSCSI option ROM. Note that only one option ROM can be used at a time.
To install the PXE option ROM:
1.
Locate the BootIMG.FLB and Bootutil.exe files in the PXE folder on your SDVD.
2.
Copy the BootIMG.FLB and Bootutil.exe files to a bootable USB storage device.
3.
Enter DOS environment.
The utility must run under pure DOS environment. It cannot run in a DOS box on Windows
system. You should boot from a DOS floppy without any device drivers.
4.
Within the DOS environment, enter the directory with the BootIMG.FLB and Bootutil.
exe files.
5.
Install the PXE option ROM:
bootutil -nic=1 -up=pxe+efi -quiet
All ports share the same flash.
6.
Restart the system.
C:\I350>bootutil -nic=1 -up=PXE+EFI -quiet
Intel(R) Ethernet Flash Firmware Utility
BootUtil version 1.5.94.2
Copyright(C) 2003-2015 Intel Corporation
Programming flash on port 1 with flash firmware image
/
Flash update successful
Port Network Address Location Series
==== =============== ======== ======= === ============================= =======
1
001FC6FFFFF1
2
001FC6FFFFF2
3
001FC6FFFFF3
4
001FC6FFFFF4
5
000C6E000072
C:\I350>
ASUS MCI-1G/350 series
WOL Flash Firmware
1:00.0 Gigabit YES UEFI,PXE Enabled
1:00.1 Gigabit YES UEFI,PXE Enabled
1:00.2 Gigabit YES UEFI,PXE Enabled
1:00.3 Gigabit YES UEFI,PXE Enabled
7:00.0 Gigabit YES FLASH UNnknown
Version
1.5.78
1.5.78
1.5.78
1.5.78
2-5
Advertisement
Table of Contents
