Toro 08733 Installation Instructions page 3

1. Saddle bracket
8. Install the toolbar into the mid-mount toolbar
system saddles as described in step 6 in the Mid-mount
Toolbar System Installation Instructions.
9. When finished, hook the long end of the extension
spring to the tab on the tool bar spring bracket
(Figure 2).
10. Connect the toolbar lift pedal and adjust the toolbar
as described in step 7 in the Mid-mount Toolbar System
Installation Instructions.
Note: If the toolbar is chattering during operation,
rotate the tines 180 degrees as shown in Figure 3.
1. Bolt
2. Retainer clip
3. Washer
2. Guard
Figure 3
4. Spring tine
5. Nut
Figure 2
3. Extension spring
3
4. Pivot bracket