Chapter 6 Hardware Setup
Serial port A
Serial port B
Parallel port
Floppy disk controller
F1 Help ↑↓ Select Item
Esc Exit ←→ Select Menu Enter Select ▼ Sub-Menu F10 Save and Exit
8-bit I/O Recovery:
16bit I/O Recovery:
Enable memory gap:
ECC Config:
SERR signal condition:
F1 Help ↑↓ Select Item
Esc Exit ←→ Select Menu Enter Select ▼ Sub-Menu
(4) If the displayed content is different, correct the setting and perform SAVE & EXIT
(5) Returning to a setup at the time of shipment is based on the following procedures.
44
Phoenix BIOS Setup Utility
Advanced
I/O Device Configuration
Base I/O address
Phoenix BIOS Setup Utility
Advanced
Advanced Chipset Control
Advanced Chipset Control screen
(F10) to save the content.
a) Load Setup Default (Exit MENU)
b) Legacy Diskette A: [Disabled] (Main MENU)
c) PS/2 Mouse: [Disabled] (Advance MENU)
d) Exit Saving Changes (Exit MENU)
[Auto]
[Disabled]
[Disabled]
[Enabled]
[Primary]
-/+ Change Values
I/O Device Configuration screen
[4.5]
[4.5]
Disabled
[ECC]
[Multiple bit]:
-/+ Change Values
Item Specific Help
F9 Setup Defaults
Item Specific Help
F9 Setup Defaults
F10 Save and Exit
Computer module C3PU35 User's Manual