Table of Contents
Advertisement
Chapter 3 Setup
1.1
POST
Power-On Self-Test (POST) is a self-diagnostic program stored in the server as standard. POST automatically
runs immediately after the server is turned on and checks the motherboard, memory, processor (CPU),
keyboard, and mouse. POST also displays the start-up messages of different utilities during the operation.
Usually, you do not need to check the messages of POST. Check messages displayed at POST in the
following cases:
When introducing a server
If you suspect a failure
When you hear beep many times during the time between power on and OS startup
When any error message is displayed
1.1.1
POST sequence
Explains how POST runs in order.
1. POST runs automatically when the server is turned on.
NEC logo appears on the screen as factory settings.
2. When Password On Boot is set to Enabled on the Security menu in the BIOS setup utility (SETUP),
the logo is displayed, and then the password entry is displayed. If you enter the wrong password three
times in a row, POST stops and you cannot proceed to the subsequent operation. In this case, turn off
and on the server.
3. If <Esc> key is pressed, the logo disappears and the details of POST are displayed.
4. POST displays several types of message. These messages let you know that the installed CPU or
connected keyboard and mouse are detected.
118
Important
Do not press any keys or perform mouse operations while POST is in
progress.
Powering on the server, after you installed or removed an optional PCI
board or moved it to another slot, may display the message that indicates
incorrect board configuration and suspend POST.
In such a case, press F1 to continue POST. Board configuration can be
made using the utility described later.
Important
Do not set a password until you install the OS.
Tips
To show the details of POST without pressing <ESC> key, set Quiet Boot to
Disabled in the Boot menu of the BIOS settings.
Express5800/T110g-E User's Guide
1. Turning on the Server
Advertisement
Table of Contents
