LG A9 Series Owner's Manual page 24

OPERATION
24
2
Open the water inlet cap
water tank and fill the tank with water using
the measuring cup
• Open only one water inlet cap to fill the
water. Opening both caps may cause the
water to flush.
• Do not fill the tank over the MAX line
• Do not put liquid other than water and hot
water in the water tank.
3
Close the water inlet cap tightly.
• If the water inlet cap is not closed properly,
water may leak.
4
Attach the water tank to the mop nozzle again.
• Insert the 2 tabs
tank into the slots
nozzle. Press down at the centre
the tank in place.
Attaching the Mop Pads
1
Wet both sides of the mop pads with water
then squeeze out any excess water before
attaching the pads.
• Do not attach pads while they are dripping
wet.
on the side of the
b
.
c
d
at the front of the water
e
on the top of the mop
f
to lock
g
• Attaching and using mop pads while they
are dry may affect the cleaning results.
.
2
Place the mop nozzle upside down on the floor.
3
Align and attach the centre of the mop pad
with the centre of the mop attachment plate.
• Attach the Velcro on the mop pad to the mop
plate. Attaching the mop pad upside down
or improperly may affect the cleaning
results.
4
Attach the mop nozzle to the appliance.
Adjusting the Amount of Water
Press the water adjustment buttons to adjust the
amount of water released onto the mop pad to
either High Mode or Low Mode.
• High Mode: Press the High Mode button
the way down to clean ingrained dirt or supply a
large amount of water.
• Low Mode: Press the Low Mode button
way down to supply a small amount of water for
cleaning wood or other flooring that can be
damaged by too much water.
• STOP: Press the Low Mode or High Mode
button halfway to toggle back to the STOP
all
a
all the
b