Preparing Product And Beer Keg - Silvercrest SBD 60 A1 Operation And Safety Notes

˜ Preparing product and beer
keg
NOTE: You can use the product exclusively
with standard 5 litre pressurized beer kegs:
– Standard 5 litre pressurized beer kegs are
equipped with a built-in CO
at the correct pressure . Without the
CO dispenser in the keg, the product
2
cannot dispense beer .
– Standard 5 litre pressurized beer kegs are
delivered with connecting parts that are
necessary to connect the beer keg
product . Without these connecting parts, the
product cannot dispense beer .
Assembling the disposable faucet
The disposable faucet is not part of the
delivery . Assembling the disposable faucet
requires parts that are delivered with the
product and parts that are delivered with the
beer keg (Fig . B and D):
22 ] [
Disposable faucet/Required parts
Beer keg parts
17 ] [
[ 18 ]
Product part
2 ] [
Remove the wrapping material from the beer
keg .
22 ] [
Between the wrapping material and the top
of the beer keg , there is a plastic case
[ 22 ]
containing the following connecting parts:
– Keg adapter
[ 17 ]
– Pre-assembled keg connector
[ 18 ]
– Short pipe
[ 19 ]
Pull the short pipe
19 ] [
connector . Discard the short pipe (Fig . D) .
[ 18 ]
24 GB/IE
dispenser
2
to the
22 ] [
Keg adapter
Keg connector
Extension pipe
, if any, out of the keg
Push an extension pipe
connector (Fig . D) . Position the extension
[ 18 ]
pipe so that its outlet points downward .
Inserting the keg connector
adapter (Fig . E):
17 ] [
– Push the handle on the keg adapter
backwards .
– Push the pin on the keg connector
through the keg adapter
– Push the handle on the keg adapter
The disposable faucet is completely assembled .
Connecting a beer keg
NOTES:
If the beer keg has been moved recently:
22 ] [
Let the beer rest before connecting the beer
keg to the product .
Once the beer keg
the beer keg inside the product for more than
5 hours .
Place the beer keg
container . Position the beer keg so that
13 ] [
the keg notch lines up with the container
21 ] [
notch (Fig . F) .
15 ] [
Position the assembled disposable faucet
so that the pin on the keg connector
positioned over the bung hole
extension pipe fits snugly into the container
[ 2 ]
notch (Fig . F) .
[ 15 ]
Push down the keg connector
pin on the keg connector pierces through the
bung hole .
20 ] [
NOTE: A small amount of beer squirts out of
the disposable faucet once the pin pierces the
bung hole .
into the keg
2 ] [
into the keg
18 ] [
[ 17 ]
[ 18 ]
.
17 ] [
up .
[ 17 ]
is opened, do not keep
22 ] [
in the cooling
22 ] [
is
[ 18 ]
and the
[ 20 ]
so that the
18 ] [